Reasons for the deviation of filter cloth from vacuum belt filter

- May 05, 2018-

In many automation industries nowadays, they are connected by conveyor belts. One of the main components of the vacuum belt filter is the filter cloth. In the process of use, it is inevitable that the filter cloth will run off. This is due to the fact that the filter cloth is loosed, the length, the parallel error and so on. In the concrete use, we will learn to analyze the reasons.


If the filter cloth is fixed to one side, it is necessary to check whether the gas source is turned on and check whether the air filter is working properly, and carry out necessary cleaning. Now the vacuum filters are all limited - bit switches. When the filter is found to be offset, it is best to check whether the limit switch is normal. When the filter cloth is in the middle, its normal position and the vertical line are 0 degrees. The contact rod should be adjusted to touch the filter cloth slightly.


After confirming that the cylinder is completely filled with gas, the angle of the middle wheel can be further adjusted at the drive side bearing. At the same time, the driving side roller bearing is moved in the slot of the driving side roller according to the direction of the filter cloth travel, so that the filter cloth is located in the middle of the filter.